Milwaukee

262-781-4970

Madison

608-221-8300

Green Bay

920-343-6496

Equipment Cold Weather Operation - Kelbe Brothers Equipment

Best Practices

Cold Weather Operation


Use the right fuel

Fueling in cold weather requires extra care to avoid water and other contaminants from entering your machine's fuel tank. Additionally, it's important to use high quality diesel that is designed specifically for winter weather operation. You should also match the fuel conditioner you use to match the type of fuel you are using. Consult your operator's manual to find the correct type of conditioner.

Always warm up the machine before use

Hoses and wires can become brittle and stressed in extreme cold conditions. To avoid damage, be sure to allow sufficient time for the engine to reach operating temperature before putting the equipment to work.

Check starting devices

Your equipment engines often need a little help to get started when the temperatures drop. Always check to make sure your block heaters and cold weather starting devices are working properly to avoid being left out in the cold when it's time to get to work.

Use the correct lubricants and condition hydraulic hoses

Before it gets too cold outside, install the correct engine, hydraulic, transmission and final drive lubricants for your exact machine. Before starting the machine, check each level to ensure they are fluid enough for proper flow. To do so, check each dipstick and, if the oil drips, then it is fluid enough.

Have an extra filter

Always keep an extra fuel filter on hand in the cab but always follow installation instructions in your operator's manual.

Keep batteries charged and warm

Cold weather requires your batteries to generate nearly twice as many cranking amps in order to turn over, so keep yours charged and warm for easy starting. If you are working in subzero temperatures, storing the battery indoors at room temperature could help when it's not in use.

Operator safety

Operators should enter and exit your machine using three points of contact. Working in snow and ice means that slips and falls are a common cause of injuries during the winter. Wear your seatbelt when operating equipment and stay alert.

For idle machines

If you are storing equipment for the winter, be sure to always start once a month when the temperature is above freezing. Avoid starting a machine in extreme cold weather and operate the hydraulic system for a brief time. Do not try to break crawler machines from a frozen situation as it can result in powertrain damage.

Milwaukee

Phone 262-781-4970
Toll Free 800-236-4970
Email info@kelbebros.com

12770 West Silver Spring Drive
Butler, Wisconsin 53007
Get Directions

Hours Monday – Friday
7:00 am – 5:00 pm

Madison

Phone 608-221-8300
Toll Free 888-221-8300
Email info@kelbebros.com

4621 Dutch Mill Road
Madison, Wisconsin 53716
Get Directions

Hours Monday – Friday
7:00 am – 5:00 pm

Green Bay

Phone 920-343-6496
Toll Free 855-414-7895
Email info@kelbebros.com

3101 French Road
De Pere, Wisconsin 54115
Get Directions

Hours Monday – Friday
7:00 am – 5:00 pm